3M™ Cold Shrink QT-III Termination Kit 7673-S-8(S), 69/72.5kV

• Compact design makes installations easier in restricted spaces
• No special tools or torch required
• Accommodates a wide range of cables in a wide range of applications
• Hi-K stress control and high dielectric constant material minimize stress

3M™ Cold Shrink QT-III Termination Kit 7673-S Series Kits let you make safe, single-phase terminations, suitable for indoor or outdoor installation on a variety of power cables. Unlike traditional kits, 3M Cold Shrink Technology allows the installer to use same installation techniques as used for 3M's medium-voltage cold shrink accessories.

Each 3M™ Cold Shrink QT-III Termination contains sufficient quantities of the following materials as appropriate to make one single-phase termination (lug not included unless requested in advance): Silicone Rubber Skirted Stress Control Assembly, Hi-K Stress Control Adapter Assembly, Lug Seal Tube, Ground Seal Tube, Ground Strap Assembly, Constant Force Springs, Tubes 3M™ Red Compound P55/R (Non-Silicone Grease), Scotch® Electrical Shielding Tape 24, 3M™ Scotch-Seal™ Mastic Sealing Tape 2229, 3M™ Copper Foil Shielding Tape 1181, Scotch® Vinyl Electrical Tape Super 88, 3M™ Cable Cleaning Pads CC-3, Scotch® Self-fusing Silicone Rubber Tape 70 and an instruction sheet.

Suggested Applications

• Terminate solid dielectric tape, longitudinally corrugated (LC), jacketed concentric neutral (JCN), tape-over-wire (TOW), or wire-over-tape (WOT) shielded power cables
• Outdoor or indoor installations