1. Canada
  2. All 3M Products
  3. Electrical
  4. Splices & Accessories
  5. Motor Lead Splices
  6. 3M™ Motor Lead Pigtail Splice Kit 5316, 5/8 kV, Non-Shielded, 8-4 AWG (Feeder), 10-4 AWG (Motor Lead)

3M™ Motor Lead Pigtail Splice Kit 5316, 5/8 kV, Non-Shielded, 8-4 AWG (Feeder), 10-4 AWG (Motor Lead)

  • 3M ID 7000027610
  • UPC 00054007083139

Fast and simple installation

No torches or heat source needed to install

Thick walls to resist puncture and abrasion damage

View more details
Frequently viewed resources
Safety Data Sheet (PDF, 0B)

Details

Highlights
  • Fast and simple installation
  • No torches or heat source needed to install
  • Thick walls to resist puncture and abrasion damage
  • Easy re-entry
  • Contains all materials required to make three splices (excluding lugs)

The 3M™ Motor Lead Pigtail Splice Kit makes three splices. Lugs are not included in kits. Feeder of 1/0 AWG-250 kcmil (60-120 sq mm), motor lead 2 AWG-250 kcmil (35-120 sq mm).

3M™ Motor Lead Pigtail Splice Kits are designed for splicing motor lead cables to incoming feeder cables, including the accommodation of pigtail (stub) connections at 1000 volts and less. The splice’s main component, the slip-on lug cover, is made from EPDM rubber. Mastic strips are used for the moisture seal. These kits are designed to be used with copper compression, one-hole lugs. After being crimped onto the cables, the lugs are bolted together in a pigtail configuration, then insulated and sealed with the 3M™ Motor Lead Splicing Kit. 3M™ Scotchlok™ Copper Compression Lugs 30000 Series, or other UL listed copper lugs, can be used (not included). Each kit includes: 3 pigtail lug covers, 3 mastic sealing strips, 3 locking pins, 3 tubes of silicone grease and an instruction sheet.

Suggested applications
  • Splicing motor lead cables to incoming feeder cables
  • Designed for use with copper compression, one- or two-hole lugs

Typical Properties

Resources